Physics – Condensed Matter – Other Condensed Matter
Scientific paper
2007-07-09
Physics
Condensed Matter
Other Condensed Matter
Scientific paper
10.1063/1.2832634
We describe here the characteristics of two types of high-quality PbTe p-n-junctions, prepared in this work: (1) by thermal diffusion of In4Te3 gas (TDJ), and (2) by ion implantation (implanted junction, IJ) of In (In-IJ) and Zn (Zn-IJ). The results, as presented here, demonstrate the high quality of these PbTe diodes. Capacitance-voltage and current-voltage characteristics have been measured. The measurements were carried out over a temperature range from ~ 10 K to ~ 180 K. The latter was the highest temperature, where the diode still demonstrated rectifying properties. This maximum operating temperature is higher than any of the earlier reported results. The saturation current density, J0, in both diode types, was ~ 10^-5 A/cm2 at 80 K, while at 180 K J0 ~ 10^-1 A/cm2 in TDJ and ~ 1 A/cm2 in both ion-implanted junctions. At 80 K the reverse current started to increase markedly at a bias of ~ 400 mV for TDJ, and at ~550 mV for IJ. The ideality factor n was about 1.5-2 for both diode types at 80 K. The analysis of the C-V plots shows that the junctions in both diode types are linearly graded. The analysis of the C-V plots allows also determining the height of the junction barrier, the concentrations and the concentration gradient of the impurities, and the temperature dependence of the static dielectric constant. The zero-bias-resistance x area products (R0Ae) at 80 K are: 850 OHMcm2 for TDJ, 250 OHMcm2 for In-IJ, and ~ 80 OHMcm2 for Zn-IJ, while at 180 K R0Ae ~ 0.38 OHMcm2 for TDJ, and ~ 0.1 OHMcm2 for IJ. The estimated detectivity is: D* ~ 10^10 cmHz^(1/2)/W up to T=140 K, determined mainly by background radiation, while at T=180 K, D* decreases to 108-107 cmHz^(1/2)/W, and is determined by the Johnson noise.
Butenko A. V.
Dashevsky Zinovi
Genikhov S.
Kahatabi R.
Kasiyan V.
No associations
LandOfFree
Characterization of high-temperature PbTe p-n junctions prepared by thermal diffusion and by ion-implantation does not yet have a rating. At this time, there are no reviews or comments for this scientific paper.
If you have personal experience with Characterization of high-temperature PbTe p-n junctions prepared by thermal diffusion and by ion-implantation, we encourage you to share that experience with our LandOfFree.com community. Your opinion is very important and Characterization of high-temperature PbTe p-n junctions prepared by thermal diffusion and by ion-implantation will most certainly appreciate the feedback.
Profile ID: LFWR-SCP-O-158952