Physics – Condensed Matter
Scientific paper
1992-08-03
Physics
Condensed Matter
17 pages (REVTEX) + 7 postscript figures
Scientific paper
10.1103/PhysRevB.47.2493
I have carried out numerical first principles calculations of the pressure dependence of the elastic moduli for several ordered structures in the Aluminum-Lithium system, specifically FCC Al, FCC and BCC Li, L1_2 Al_3Li, and an ordered FCC Al_7Li supercell. The calculations were performed using the full potential linear augmented plane wave method (LAPW) to calculate the total energy as a function of strain, after which the data was fit to a polynomial function of the strain to determine the modulus. A procedure for estimating the errors in this process is also given. The predicted equilibrium lattice parameters are slightly smaller than found experimentally, consistent with other LDA calculations. The computed elastic moduli are within approximately 10% of the experimentally measured moduli, provided the calculations are carried out at the experimental lattice constant. The LDA equilibrium shear modulus C11-C12 increases from 59.3 GPa in Al, to 76.0 GPa in Al_7Li, to 106.2 GPa in Al_3Li. The modulus C_44 increases from 38.4 GPa in Al to 46.1 GPa in Al_7Li, then falls to 40.7 GPa in Al_3Li. All of the calculated elastic moduli increase with pressure with the exception of BCC Li, which becomes elastically unstable at about 2 GPa, where C_11-C_12 vanishes.
No associations
LandOfFree
Pressure Dependence of the Elastic Moduli in Aluminum Rich Al-Li Compounds does not yet have a rating. At this time, there are no reviews or comments for this scientific paper.
If you have personal experience with Pressure Dependence of the Elastic Moduli in Aluminum Rich Al-Li Compounds, we encourage you to share that experience with our LandOfFree.com community. Your opinion is very important and Pressure Dependence of the Elastic Moduli in Aluminum Rich Al-Li Compounds will most certainly appreciate the feedback.
Profile ID: LFWR-SCP-O-519929