Physics – Condensed Matter – Materials Science
Scientific paper
2012-01-17
Journal of Materials Science 47 (2012) 4305-4312
Physics
Condensed Matter
Materials Science
29 pages, 10 figures, accepted for publication in Journal of Materials Science
Scientific paper
10.1007/s10853-012-6281-x
This paper reports on a new and swift hydrothermal chemical route to prepare titanate nanostructures (TNS) avoiding the use of crystalline TiO2 as starting material. The synthesis approach uses a commercial solution of TiCl3 as titanium source to prepare an amorphous precursor, circumventing the use of hazardous chemical compounds. The influence of the reaction temperature and dwell autoclave time on the structure and morphology of the synthesised materials was studied. Homogeneous titanate nanotubes with a high length/diameter aspect ratio were synthesised at 160^{\circ}C and 24 h. A band gap of 3.06\pm0.03 eV was determined for the TNS samples prepared in these experimental conditions. This value is red shifted by 0.14 eV compared to the band gap value usually reported for the TiO2 anatase. Moreover, such samples show better adsorption capacity and photocatalytic performance on the dye rhodamine 6G (R6G) photodegradation process than TiO2 nanoparticles. A 98% reduction of the R6G concentration was achieved after 45 minutes of irradiation of a 10 ppm dye aqueous solution and 1 g/L of TNS catalyst.
Monteiro O. C.
Nunes M. R.
Silvestre A. J.
Ylhainen E. K.
No associations
LandOfFree
Synthesis of titanate nanostructures using amorphous precursor material and their adsorption/photocatalytic properties does not yet have a rating. At this time, there are no reviews or comments for this scientific paper.
If you have personal experience with Synthesis of titanate nanostructures using amorphous precursor material and their adsorption/photocatalytic properties, we encourage you to share that experience with our LandOfFree.com community. Your opinion is very important and Synthesis of titanate nanostructures using amorphous precursor material and their adsorption/photocatalytic properties will most certainly appreciate the feedback.
Profile ID: LFWR-SCP-O-395824