SQUID based resistance bridge for shot noise measurement on low impedance samples

Details SQUID based resistance bridge for shot noise measurement on low impedance samples SQUID based resistance bridge for shot noise measurement on low impedance samples

1999-01-11

arxiv.org/abs/cond-mat/9901090v2

Physics

Condensed Matter

Mesoscale and Nanoscale Physics

4 pages, revtex, to appear in Rev. Sci. Instr (scheduled june 99)

Scientific paper

We present a resistance bridge which uses a SQUID to measure the shot noise in low impedance samples. The experimental requirements are high DC bias currents (typically 10mA) together with high AC sensitivity (pA/VHz). This system is used to investigate the shot noise in Superconductor/Normal/Superconductor junctions where Andreev reflection enhanced shot noise is expected. Because our setup has an intrinsic noise much smaller than the thermal noise of the resistance bridge at 4.2K, reliable results can be obtained on impedances out of the range of classical measurement schemes.

Affiliated with

Also associated with

No associations

Rating

SQUID based resistance bridge for shot noise measurement on low impedance samples does not yet have a rating. At this time, there are no reviews or comments for this scientific paper.

If you have personal experience with SQUID based resistance bridge for shot noise measurement on low impedance samples, we encourage you to share that experience with our LandOfFree.com community. Your opinion is very important and SQUID based resistance bridge for shot noise measurement on low impedance samples will most certainly appreciate the feedback.

Rate now

Comments { 0 }

Profile ID: LFWR-SCP-O-62623