Computer Science – Performance
Scientific paper
May 1998
adsabs.harvard.edu/cgi-bin/nph-data_query?bibcode=1998spie.3351..310l&link_type=abstract
Proc. SPIE Vol. 3351, p. 310-319, Telescope Control Systems III, Hilton Lewis; Ed.
Computer Science
Performance
7
Scientific paper
During the design phase of the Green Bank Telescope (GBT), various means of providing an accurate surface on a large aperture paraboloid, were considered. Automated jacks supporting the primary reflector were selected as the appropriate technology since they promised greater performance and potentially lower costs than a homologous or carbon fiber design, and had certain advantages over an active secondary. The design of the active surface has presented many challenges. Since the actuators are mounted on a tipping structure, it was required that they support a significant side-load. Such devices were not readily available commercially so they had to be developed. Additional actuator requirements include low backlash, repeatable positioning, and an operational life of at least 230 years. Similarly, no control system capable of controlling the 2209 actuators was commercially available. Again a prime requirement was reliability. Maintaining was also a very important consideration. The system architecture is tree-like. An active surface 'master-computer' controls interaction with the telescope control system, and controls ancillary equipment such as power supplies and temperature monitors. Two slave computers interface with the master- computer, and each closes approximately 1100 position loops. For simplicity, the servo is an 'on/off' type, yet achieves a positioning resolution of 25 microns. Each slave computer interfaces with 4 VME I/O cards, which in turn communicate with 140 control modules. The control modules read out the positions of the actuators every 0.1 sec and control the actuators' DC motors. Initial control of the active surface will be based on an elevation dependant structural model. Later, the model will be improved by holographic observations.Surface accuracy will be improved further by using laser ranging system which will actively measure the surface figure. Several tests have been conducted to assure that the system will perform as desired when installed on the telescope. These include actuator life tests, motor life test, position transducer accuracy test, as well as positioning accuracy tests.
No associations
LandOfFree
Green Bank Telescope active surface system does not yet have a rating. At this time, there are no reviews or comments for this scientific paper.
If you have personal experience with Green Bank Telescope active surface system, we encourage you to share that experience with our LandOfFree.com community. Your opinion is very important and Green Bank Telescope active surface system will most certainly appreciate the feedback.
Profile ID: LFWR-SCP-O-1047331