Physics – Condensed Matter – Materials Science
Scientific paper
2008-06-18
Rev. Sci. Instrum. 79, 093909 (2008)
Physics
Condensed Matter
Materials Science
Scientific paper
10.1063/1.2972172
We describe a low-cost and simple setup for hyperthermia measurements on colloidal solutions of magnetic nanoparticles (ferrofluids) with a frequency-adjustable magnetic field in the range 5-500 kHz produced by an electromagnet. By optimizing the general conception and each component (nature of the wires, design of the electromagnet), a highly efficient setup is obtained. For instance, in a useful gap of 1.1 cm, a magnetic field of 4.8 mT is generated at 100 kHz and 500 kHz with an output power of 3.4 W and 75 W, respectively. A maximum magnetic field of 30 mT is obtained at 100 kHz. The temperature of the colloidal solution is measured using optical fiber sensors. To remove contributions due to heating of the electromagnet, a differential measurement is used. In this configuration the sensitivity is better than 1.5 mW at 100 kHz and 19.3 mT. This setup allows one to measure weak heating powers on highly diluted colloidal solutions. The hyperthermia characteristics of a solution of Fe nanoparticles are described, where both the magnetic field and the frequency dependence of heating power have been measured.
Carrey Julian
Lacroix L.-M.
Respaud Marc
No associations
LandOfFree
A frequency-adjustable electromagnet for hyperthermia measurements on magnetic nanoparticles does not yet have a rating. At this time, there are no reviews or comments for this scientific paper.
If you have personal experience with A frequency-adjustable electromagnet for hyperthermia measurements on magnetic nanoparticles, we encourage you to share that experience with our LandOfFree.com community. Your opinion is very important and A frequency-adjustable electromagnet for hyperthermia measurements on magnetic nanoparticles will most certainly appreciate the feedback.
Profile ID: LFWR-SCP-O-272992