Multi-Band Dipole And Multipole Wakefields In NLC Traveling Wave Accelerators Using A Wire Measurement Technique

Physics – Accelerator Physics

Scientific paper

Rate now

  [ 0.00 ] – not rated yet Voters 0   Comments 0

Details

Paper presented at the 2002 8th European Particle Accelerator Conference (EPAC 2002) Paris, France, June 3rd -June 7th, 2002

Scientific paper

Dipole wakefields in NLC (Next Linear Collider) structures have been measured with ASSET [1] and well predicted by a circuit model [2]. However, the experimental technique is both time-consuming and expensive. Here, we report on kick factor and synchronous frequency determination for 1st and higher order dipole bands for TW (Traveling Wave) accelerators via a wire measurement technique. This stand-alone technique is relatively inexpensive and may lead to an efficient determination of wakefield parameters. The perturbative effect of the wire on the dipole band is pointed out and a two-wire scheme with a limited perturbative effect is also discussed. [1] C. Adolphsen, 1997, SLAC-PUB-7519 [2] R.M. Jones et al, LINAC96, SLAC-PUB-7287

No associations

LandOfFree

Say what you really think

Search LandOfFree.com for scientists and scientific papers. Rate them and share your experience with other people.

Rating

Multi-Band Dipole And Multipole Wakefields In NLC Traveling Wave Accelerators Using A Wire Measurement Technique does not yet have a rating. At this time, there are no reviews or comments for this scientific paper.

If you have personal experience with Multi-Band Dipole And Multipole Wakefields In NLC Traveling Wave Accelerators Using A Wire Measurement Technique, we encourage you to share that experience with our LandOfFree.com community. Your opinion is very important and Multi-Band Dipole And Multipole Wakefields In NLC Traveling Wave Accelerators Using A Wire Measurement Technique will most certainly appreciate the feedback.

Rate now

     

Profile ID: LFWR-SCP-O-646290

  Search
All data on this website is collected from public sources. Our data reflects the most accurate information available at the time of publication.