Physics – Accelerator Physics
Scientific paper
2011-10-13
Physics
Accelerator Physics
Scientific paper
The level of current non-uniformity in NbTi CICCs sections near the joints in combination with the magnet field profile needs attention in view of proper joint design. The strand Joule power and current distribution at quench under DC conditions of two samples of ITER Poloidal Field Coil conductors, as tested in the SULTAN facility and of the so called PFCI Model Coil Insert, have been analyzed with the numerical cable model JackPot. The precise trajectories of all individual strands, joint design, cabling configuration, spatial distribution of the magnetic field, sample geometry and using experimentally determined interstrand resistance distributions have been taken into account. Although unable to predict the quench point due to the lack of a thermal-hydraulic routine, the model allows to assess the instantaneous strand power at quench and its local distribution in the cable, showing the hot spots, once the quench conditions in terms of current and temperature are experimentally known., The analysis points out the relation of the above mentioned factors with the DC quench stability of both short samples and coils. The possible small scale and local electrical-thermal interactions were ignored in order to examine the relevance of such effects in the overall prediction of the CICC performance The electromagnetic code shows an excellent quantitative predictive potential for CICC transport properties, excluding any freedom for matching the results. The influence of the local thermal effects in the modeling is identified as being marginal and far less than the generally accepted temperature margin for safe operation.
Nijhuis A.
Rolando G.
van Lanen P. A. E.
No associations
LandOfFree
Minimum quench power dissipation and current non-uniformity in ITER type NbTi cable-in-conduit conductor samples under DC conditions does not yet have a rating. At this time, there are no reviews or comments for this scientific paper.
If you have personal experience with Minimum quench power dissipation and current non-uniformity in ITER type NbTi cable-in-conduit conductor samples under DC conditions, we encourage you to share that experience with our LandOfFree.com community. Your opinion is very important and Minimum quench power dissipation and current non-uniformity in ITER type NbTi cable-in-conduit conductor samples under DC conditions will most certainly appreciate the feedback.
Profile ID: LFWR-SCP-O-500917