Inviscid behaviour of fines-rich pyroclastic flows inferred from experiments on gas-particle mixtures [rapid communication]

Details Inviscid behaviour of fines-rich pyroclastic flows inferred from experiments on gas-particle mixtures [rapid communication] Inviscid behaviour of fines-rich pyroclastic flows inferred from experiments on gas-particle mixtures [rapid communication]

Dec 2005

adsabs.harvard.edu/cgi-bin/nph-data_query?bibcode=2005e%26psl.240..401r&link_type=abstract

Earth and Planetary Science Letters, Volume 240, Issue 2, p. 401-414.

Physics

10

Scientific paper

Experiments were carried out on granular flows generated by instantaneous release of gas-fluidised, bidisperse mixtures and propagating into a horizontal channel. The mixture consists of fine (< 100 μm) and coarse (> 100 μm) particles of same density, with corresponding grain size ratios of ˜ 2 to 9. Initial fluidisation of the mixture destroys the interparticle frictional contacts, and the flow behaviour then depends on the initial bed packing and on the timescale required to re-establish strong frictional contacts. At a fines mass fraction (α) below that of optimal packing (˜ 40%), the initial mixtures consist of a continuous network of coarse particles with fines in interstitial voids. Strong frictional contacts between the coarse particles are probably rapidly re-established and the flows steadily decelerate. Some internal friction reduction appears to occur as α and the grain size ratio increases, possibly due to particle rolling and the lower roughness of internal shear surfaces. Segregation only occurs at large grain size ratio due to dynamical sieving with fines concentrated at the flow base. In contrast, at α above that for optimal packing, the initial mixtures consist of coarse particles embedded in a matrix of fines. Flow velocities and run-outs are similar to that of the monodisperse fine end-member, thus showing that the coarse particles are transported passively within the matrix whatever their amount and grain size are. These flows propagate at constant height and velocity as inviscid fluid gravity currents, thus suggesting negligible interparticle friction. We have determined a Froude number of 2.61 ± 0.08 consistent with the dam-break model for fluid flows, and with no significant variation as a function of α, the grain size ratio, and the initial bed expansion. Very little segregation occurs, which suggests low intensity particle interactions during flow propagation and that active fluidisation is not taking place. Strong frictional contacts are only re-established in the final stages of emplacement and stop the flow motion. We infer that fines-rich (i.e. matrix-supported) pyroclastic flows propagate as inviscid fluid gravity currents for most of their emplacement, and this is consistent with some field data.

Affiliated with

Also associated with

No associations

Rating

Inviscid behaviour of fines-rich pyroclastic flows inferred from experiments on gas-particle mixtures [rapid communication] does not yet have a rating. At this time, there are no reviews or comments for this scientific paper.

If you have personal experience with Inviscid behaviour of fines-rich pyroclastic flows inferred from experiments on gas-particle mixtures [rapid communication], we encourage you to share that experience with our LandOfFree.com community. Your opinion is very important and Inviscid behaviour of fines-rich pyroclastic flows inferred from experiments on gas-particle mixtures [rapid communication] will most certainly appreciate the feedback.

Rate now

Comments { 0 }

Profile ID: LFWR-SCP-O-1430081