Impedance Measurement Setup for Higher-Order Mode Studies in NLC Accelerator Structures with the Wire Method

Details Impedance Measurement Setup for Higher-Order Mode Studies in NLC Accelerator Structures with the Wire Method Impedance Measurement Setup for Higher-Order Mode Studies in NLC Accelerator Structures with the Wire Method

2002-09-20

arxiv.org/abs/physics/0209074v1

Physics

Accelerator Physics

3 pages Presented at Linac 2002, Gyeongju, Korea, Aug. 19-23, 2002

Scientific paper

Dipole modes are the main cause of transverse emittance dilution in the Japanese Linear Collider / Next Linear Collider (JLC/NLC). A diagnostic setup has been built in order to investigate them. The method is based on using a coaxial wire to excite and measure electromagnetic modes of accelerating structures. This method can offer a more efficient and less expensive procedure than the ASSET facility. Initial measurements have been made and are presented in this paper.

Affiliated with

Also associated with

No associations

Rating

Impedance Measurement Setup for Higher-Order Mode Studies in NLC Accelerator Structures with the Wire Method does not yet have a rating. At this time, there are no reviews or comments for this scientific paper.

If you have personal experience with Impedance Measurement Setup for Higher-Order Mode Studies in NLC Accelerator Structures with the Wire Method, we encourage you to share that experience with our LandOfFree.com community. Your opinion is very important and Impedance Measurement Setup for Higher-Order Mode Studies in NLC Accelerator Structures with the Wire Method will most certainly appreciate the feedback.

Rate now

Comments { 0 }

Profile ID: LFWR-SCP-O-224581