Development of lightweight mirror elements for the Euro50 mirrors

Physics – Optics

Scientific paper

Rate now

  [ 0.00 ] – not rated yet Voters 0   Comments 0

Details

1

Scientific paper

New, very large telescopes with apertures of 30, 50, and 100 meters are being proposed by the astronomical community. Superpolished or ultrapolished mirrors with low scattered light levels and the use of adaptive optics for near-diffraction-limited performance would make such large telescopes a turning point in astronomy. The secondary mirror for the Euro50 will be a four meter adaptive optic made of a low expansion graphite-filled cyanate ester resin composite produced using a replica transfer technique. We have made three 1/3rd meter diameter prototype composite adaptive optic mirrors of this cyanate ester composite material. Because of the embedded graphite fibers, the composite material has a measured expansion coefficient in the 10-8 range, as has Zerodur or ULE glass. It is very much lighter, more rugged and more economical than Zerodur or ULE, and can be fabricated in weeks, not months. The Zerodur mandrels upon which these replica transfer mirrors are made are superpolished using centrifugal elutriation, so the replica surface has an rms roughness of 0.6 to 0.8 nm. It thus scatters about an order of magnitude less light than typical conventionally polished astronomical mirrors. In adaptive optic mirrors with sub-mm thick faceplates the number of plies used is insufficient to produce an isotropic surface. For mirrors 2 mm thick, with more plies, the surfaces are isotropic, and the slight astigmatism sometimes resulting from the mesh in the ply can be corrected by actuators to make them attractive mirrors. They must be supported to maintain a good optical figure over a meter diameter mirror. The support requirement may be met by using a new type of mechanical/piezoelectric actuator adjustable to a fraction of a wavelength. The mechanical actuators have a coarse adjust of over an mm and a fine adjust of less than a wavelength of light. They can be used in series with a novel type of piezoelectric actuator for final static adjustment. The low voltage, up to 2.5 kHz frequency piezoelectric actuators have a displacement of approximately one μm per volt, 82 times greater than conventional piezoelectric actuators, and a throw of +/-30 μm or more. Compliant faceplates can be adaptive as well as active. Calculations indicate that for actuator spacings of about 4 cm the effective mirror stiffness equals that of a solid Zerodur mirror with a conventional 6:1 diameter to thickness ratio. The effect of gravitational sag for composite mirrors is calculated to be negligible. They are thus a good choice for the secondary mirror for the Euro50 as well as for the primary or secondary mirrors for other giant telescopes.

No associations

LandOfFree

Say what you really think

Search LandOfFree.com for scientists and scientific papers. Rate them and share your experience with other people.

Rating

Development of lightweight mirror elements for the Euro50 mirrors does not yet have a rating. At this time, there are no reviews or comments for this scientific paper.

If you have personal experience with Development of lightweight mirror elements for the Euro50 mirrors, we encourage you to share that experience with our LandOfFree.com community. Your opinion is very important and Development of lightweight mirror elements for the Euro50 mirrors will most certainly appreciate the feedback.

Rate now

     

Profile ID: LFWR-SCP-O-772927

  Search
All data on this website is collected from public sources. Our data reflects the most accurate information available at the time of publication.