Designing for frequency and time metrology at the 10 to the minus 18 power level

Details Designing for frequency and time metrology at the 10 to the minus 18 power level Designing for frequency and time metrology at the 10 to the minus 18 power level

Jun 1992

adsabs.harvard.edu/cgi-bin/nph-data_query?bibcode=1992esasp.340..477w&link_type=abstract

In ESA, Frequency and Time Forum p 477-481 (SEE N93-24978 09-70)

Physics

Frequency Measurement, Frequency Stability, Frequency Standards, Metrology, Time Measurement, Algorithms, Carrier To Noise Ratios, Errors, Phase Detectors, Signal To Noise Ratios, Signal Transmission, White Noise

Scientific paper

Some of the key parameters that significantly affect the overall architecture of a system that is being designed to measure frequency or time accuracy to 3 by 10(exp -18) are examined. Specifically, the following are investigated: the timing errors in signal transmission for distances up to 100 m; the effect of changes in temperature and RF amplitude on timing (low frequency) errors in several available phase detectors; and the influence of measurement algorithms on the allowable level of white phase noise in the system as a function of the carrier frequency.

Affiliated with

Also associated with

No associations

Rating

Designing for frequency and time metrology at the 10 to the minus 18 power level does not yet have a rating. At this time, there are no reviews or comments for this scientific paper.

If you have personal experience with Designing for frequency and time metrology at the 10 to the minus 18 power level, we encourage you to share that experience with our LandOfFree.com community. Your opinion is very important and Designing for frequency and time metrology at the 10 to the minus 18 power level will most certainly appreciate the feedback.

Rate now

Comments { 0 }

Profile ID: LFWR-SCP-O-1203825