Characterisation of the VELO High Voltage System

Details Characterisation of the VELO High Voltage System Characterisation of the VELO High Voltage System

2008-08-13

arxiv.org/abs/0808.1857v1

Physics

Instrumentation and Detectors

Scientific paper

The high voltage system supplies the bias voltage to the 88 silicon sensors which comprise the LHCb Vertex Locator (VELO). This note describes the results of the tests which have been performed on the hardware of the high voltage system of the VELO. Each individual test detailed in this note corresponds to a specific requirement of the system. These requirements arise primarily from ensuring the safety of the silicon sensors and the quality of the data taken from the VELO modules. The tests performed are in four categories: normal operation of the high voltage system; verification of its stability under operation; discussion of its behaviour in failure modes; and details of operation at low voltage. Noteworthy issues, identified through the tests, include the behaviour of the high voltage modules at voltages below 9V, the current limit that can be applied during ramping of the voltage, and the speed with which the voltage is cut during failures of the system. The results of these tests provide high confidence that the high voltage system can be safely used and demonstrate that low noise is produced by the power supplies.

Affiliated with

Also associated with

No associations

Rating

Characterisation of the VELO High Voltage System does not yet have a rating. At this time, there are no reviews or comments for this scientific paper.

If you have personal experience with Characterisation of the VELO High Voltage System, we encourage you to share that experience with our LandOfFree.com community. Your opinion is very important and Characterisation of the VELO High Voltage System will most certainly appreciate the feedback.

Rate now

Comments { 0 }

Profile ID: LFWR-SCP-O-387006