Beam test of the QMB6 calibration board and HBU0 prototype

Details Beam test of the QMB6 calibration board and HBU0 prototype Beam test of the QMB6 calibration board and HBU0 prototype

2011-05-24

arxiv.org/abs/1105.4745v1

Physics

Instrumentation and Detectors

12 pages, 16 figures, EUDET project memo

Scientific paper

We report about the performance of the HBU0 board and the optical calibration system QMB6 in the DESY test beam. A MIP signal was measured on the HBU0 board, providing a reference to the LED amplitude scan, showing an amount of light delivered to each of 12 SiPMs from 0 to 250 MIP at maximum. An ASIC analogue memory cell performance was analyzed in relation with the SiPM signal strength. We observed a non-uniformity and a pedestal shift in the ASIC readout values in the high gain mode for the higher signals strength.

Affiliated with

Also associated with

No associations

Rating

Beam test of the QMB6 calibration board and HBU0 prototype does not yet have a rating. At this time, there are no reviews or comments for this scientific paper.

If you have personal experience with Beam test of the QMB6 calibration board and HBU0 prototype, we encourage you to share that experience with our LandOfFree.com community. Your opinion is very important and Beam test of the QMB6 calibration board and HBU0 prototype will most certainly appreciate the feedback.

Rate now

Comments { 0 }

Profile ID: LFWR-SCP-O-515784