Stability of Water Ice Beneath Porous Dust Layers of the Martian South Polar Terrain

Details Stability of Water Ice Beneath Porous Dust Layers of the Martian South Polar Terrain Stability of Water Ice Beneath Porous Dust Layers of the Martian South Polar Terrain

Aug 2000

adsabs.harvard.edu/cgi-bin/nph-data_query?bibcode=2000mpse.conf...90k&link_type=abstract

International Conference on Mars Polar Science and Exploration, p. 90

Physics

Diurnal Variations, Dust, Mars (Planet), Mars Surface, Polar Regions, Surface Layers, Planetary Geology, Terrain Analysis, Water, Ice, Southern Hemisphere, Annual Variations, Deposits, Heat Transfer, Mars Polar Lander, Thermal Mapping, Water Temperature, Porosity, Stability

Scientific paper

The analysis of the Viking Infrared Thermal Mapper (IRTM) data show that the surface layers of the Mars south polar layered deposits have very low thermal inertia between 75 and 125 J/(sq m)(s-1/2)(K-1). This is consistent with the assumption that the surface is covered by a porous layer of fine dust. Paige and Keegan determined a slightly higher value based on a thermal model similar to that of Kieffer et al. In this model the heat transfer equation is used to estimate the thickness of the layer that protects the ground ice from seasonal and diurnal temperature variations. The physical properties of the layer are unimportant as long as it has a low thermal inertia and conductivity and keeps the temperature at the ice boundary low enough to prevent sublimation. A thickness between 20 and 4 cm was estimated. This result can be considered to be an upper limit. We assume the surface to be covered by a porous dust layer and consider the gas diffusion through it, from the ground ice and from the atmosphere. Then the depth of the layer is determined by the mass flux balance of subliming and condensing water and not by the temperature condition. The dust particles in the atmosphere are of the order 1 gm. On the surface we can expect larger grains (up to sand size). Therefore assuming an average pore size of 10 gm, a volume porosity of 0.5, a heat capacity of 1300 J/(kg-1)(K-1) leads to a thermal inertia of approx. 80 J/(sq m)(s-1/2)(K-1). With these parameters a dust layer of only 5 mm thickness is found to establish the flux balance at the ice-dust interface during spring season in the southern hemisphere at high latitudes (where Mars Polar Lander arrived). The diurnal temperature variation at the ice-dust surface is shown. The maximum of 205 K well exceeds the sublimation temperature of water ice at 198 K under the atmospheric conditions. The corresponding vapour flux during the last day is shown together with the flux condensing from the atmosphere. The calculations show that the sub-surface ice on Mars can be thermodynamically and dynamically stable even if it is protected by a porous dust layer of only a few millimetres in thickness.

Affiliated with

Also associated with

No associations

Rating

Stability of Water Ice Beneath Porous Dust Layers of the Martian South Polar Terrain does not yet have a rating. At this time, there are no reviews or comments for this scientific paper.

If you have personal experience with Stability of Water Ice Beneath Porous Dust Layers of the Martian South Polar Terrain, we encourage you to share that experience with our LandOfFree.com community. Your opinion is very important and Stability of Water Ice Beneath Porous Dust Layers of the Martian South Polar Terrain will most certainly appreciate the feedback.

Rate now

Comments { 0 }

Profile ID: LFWR-SCP-O-741839