Astronomy and Astrophysics – Astrophysics
Scientific paper
2001-03-07
Astronomy and Astrophysics
Astrophysics
13 pages, accepted by Publications of the Astronomical Society of the Pacific
Scientific paper
10.1086/320288
Optical interferometers increasingly use single-mode fibers as spatial filters to convert varying wavefront distortion into intensity fluctuations which can be monitored for accurate calibration of fringe amplitudes. Here I propose using an asymmetric coupler to allow the photometric intensities of each telescope beam to be measured at the same time as the fringe visibility, but without the need for dedicated photometric outputs, which reduce the light throughput in the interferometric channels. In the read-noise limited case often encountered in the infrared, I show that a 53% improvement in signal-to-noise ratio for the visibility amplitude measurement is achievable, when compared to a balanced coupler setup with 50% photometric taps (e.g., the FLUOR experiment). In the Poisson-noise limit appropriate for visible light, the improvement is reduced to only ~8%. This scheme also reduces the cost and complexity of the beam combination since fewer components and detectors are required, and can be extended to more than two telescopes for "all-in-one" or pair-wise beam combination. Asymmetric beam combination can also be employed for monitoring scintillation and throughput variations in systems without spatial filtering.
No associations
LandOfFree
Asymmetric Beam Combination for Optical Interferometry does not yet have a rating. At this time, there are no reviews or comments for this scientific paper.
If you have personal experience with Asymmetric Beam Combination for Optical Interferometry, we encourage you to share that experience with our LandOfFree.com community. Your opinion is very important and Asymmetric Beam Combination for Optical Interferometry will most certainly appreciate the feedback.
Profile ID: LFWR-SCP-O-490473