A new method of determining the initial size and Lorentz factor of gamma-ray burst fireballs using a thermal emission component

Astronomy and Astrophysics – Astrophysics

Scientific paper

Rate now

  [ 0.00 ] – not rated yet Voters 0   Comments 0

Details

Discussion added on gamma-ray emission efficiency. Accepted for publication in Ap.J. Lett

Scientific paper

10.1086/520534

In recent years increasing evidence has emerged for a thermal component in the gamma- and X-ray spectrum of the prompt emission phase in gamma-ray bursts. The temperature and flux of the thermal component show a characteristic break in the temporal behavior after a few seconds. We show here, that measurements of the temperature and flux of the thermal component at early times (before the break) allow the determination of the values of two of the least restricted fireball model parameters: the size at the base of the flow and the outflow bulk Lorentz factor. Relying on the thermal emission component only, this measurement is insensitive to the inherent uncertainties of previous estimates of the bulk motion Lorentz factor. We give specific examples of the use of this method: for GRB970828 at redshift z=0.9578, we show that the physical size at the base of the flow is r_0 = (2.9+-1.8)*10^8 Y_0^{-3/2} cm and the Lorentz factor of the flow is Gamma = (305\+-28) Y_0^{1/4}, and for GRB990510 at z=1.619, r_0=(1.7+-1.7)*10^8 Y_0^{-3/2} cm and Gamma=(384+-71) Y_0^{1/4}, where Y = 1 Y_0 is the ratio between the total fireball energy and the energy emitted in gamma- rays.

No associations

LandOfFree

Say what you really think

Search LandOfFree.com for scientists and scientific papers. Rate them and share your experience with other people.

Rating

A new method of determining the initial size and Lorentz factor of gamma-ray burst fireballs using a thermal emission component does not yet have a rating. At this time, there are no reviews or comments for this scientific paper.

If you have personal experience with A new method of determining the initial size and Lorentz factor of gamma-ray burst fireballs using a thermal emission component, we encourage you to share that experience with our LandOfFree.com community. Your opinion is very important and A new method of determining the initial size and Lorentz factor of gamma-ray burst fireballs using a thermal emission component will most certainly appreciate the feedback.

Rate now

     

Profile ID: LFWR-SCP-O-272078

  Search
All data on this website is collected from public sources. Our data reflects the most accurate information available at the time of publication.