Sliced zone plate for hard x-ray sources: manufacturing and testing

Details Sliced zone plate for hard x-ray sources: manufacturing and testing Sliced zone plate for hard x-ray sources: manufacturing and testing

Jul 1997

adsabs.harvard.edu/cgi-bin/nph-data_query?bibcode=1997spie.3113..384a&link_type=abstract

Proc. SPIE Vol. 3113, p. 384-392, Grazing Incidence and Multilayer X-Ray Optical Systems, Richard B. Hoover; Arthur B. Walker; E

Computer Science

Scientific paper

Fresnel hard x-ray zone plate was manufactured by sputter- sliced technology to work on 2.29 A wavelength. Cu and Cr were used to create opaque and transparent zones. The experimental setup was prepared to investigate optical properties of obtained zone plate. The focusing effect was observed. The numerical methods and software were developed to simulate imaging properties of Fresnel zone plate. Experimental data was compared with calculations.

Affiliated with

Also associated with

No associations

Rating

Sliced zone plate for hard x-ray sources: manufacturing and testing does not yet have a rating. At this time, there are no reviews or comments for this scientific paper.

If you have personal experience with Sliced zone plate for hard x-ray sources: manufacturing and testing, we encourage you to share that experience with our LandOfFree.com community. Your opinion is very important and Sliced zone plate for hard x-ray sources: manufacturing and testing will most certainly appreciate the feedback.

Rate now

Comments { 0 }

Profile ID: LFWR-SCP-O-1417231