Shear wave velocity structure of the İzmit Bay area (Turkey) estimated from active-passive array surface wave and single-station microtremor methods

Astronomy and Astrophysics – Astronomy

Scientific paper

Rate now

  [ 0.00 ] – not rated yet Voters 0   Comments 0

Details

2

Surface Waves And Free Oscillations, Site Effects

Scientific paper

To provide quantitative information on the shear wave velocity structure of the İzmit Bay area, we conduct active-passive array surface wave and single-station microtremor measurements at 60 sites. We process these array measurements to produce combined Rayleigh wave dispersion curves that span a broad-frequency range (0.5-20 Hz). We also make use of horizontal-to-vertical spectral ratio (HVSR) curves obtained from the single-station microtremor measurements to benefit from their close relation to the ellipticity of Rayleigh waves. Using the dispersion curve sensitivity to the absolute velocities and the shape of the HVSR curve sensitivity to the velocity contrasts of the velocity-depth model, we have applied a combined inversion technique to derive better constrained shear velocity models at each site. The derived shear velocity models are used to provide a Vs30 site classification map and information on the sediment-bedrock structure for the İzmit Bay area. The Vs30 map shows that the entire shoreline regions including artificial infill areas of the İzmit Bay have Vs30 values less than 200 m s-1, locally as low as 80 m s-1. The older sediment areas of the İzmit basin have Vs30 values ranging between 250 and 350 m s-1. The highest Vs30 values are associated with rock sites reaching about 950-1300 m s-1. We also present a high correlation between the Vs30 values and the phase velocity of Rayleigh wave corresponding to the 40 m wavelength (C40). The important implication of this correlation is that Vs30 may be estimated from C40 without inverting the dispersion curve. The inferred sediment-bedrock interface along a cross-section shows an antisymmetric V shaped basin with a sedimentary cover thickness reaching about 1200 m at the deepest part of the İzmit basin. This deepest part coincides in the map view where the North Anatolian fault zone crosses the basin in the east-west direction. The sedimentary cover thickness is found to be 750 m in the Gölcük-Derince basin.

No associations

LandOfFree

Say what you really think

Search LandOfFree.com for scientists and scientific papers. Rate them and share your experience with other people.

Rating

Shear wave velocity structure of the İzmit Bay area (Turkey) estimated from active-passive array surface wave and single-station microtremor methods does not yet have a rating. At this time, there are no reviews or comments for this scientific paper.

If you have personal experience with Shear wave velocity structure of the İzmit Bay area (Turkey) estimated from active-passive array surface wave and single-station microtremor methods, we encourage you to share that experience with our LandOfFree.com community. Your opinion is very important and Shear wave velocity structure of the İzmit Bay area (Turkey) estimated from active-passive array surface wave and single-station microtremor methods will most certainly appreciate the feedback.

Rate now

     

Profile ID: LFWR-SCP-O-1495239

  Search
All data on this website is collected from public sources. Our data reflects the most accurate information available at the time of publication.