Other
Scientific paper
Oct 2004
adsabs.harvard.edu/cgi-bin/nph-data_query?bibcode=2004icar..171..372s&link_type=abstract
Icarus, Volume 171, Issue 2, p. 372-390.
Other
14
Saturn, Resonances, Data Reduction Techniques
Scientific paper
We have undertaken an analysis of the Voyager photopolarimeter (PPS) stellar occultation data of Saturn's A ring. The Voyager PPS observed the bright star δ Scorpii as it was occulted by Saturn's main rings during the spacecraft flyby of the Saturn system in 1981. The occultation measurement produced a ring profile with radial resolution of approximately 100 m, and radial structure is evident in the profile down to the resolution limit. We have applied an autoregressive technique to the data for estimating the power spectrum as a function of radius, which has allowed us to identify 40 spiral density waves in Saturn's A ring, associated with the strongest torques due to forcing from the moons. The majority of the detected waves are observed to disperse linearly in regions beginning a few kilometers from the resonance location. We have used the dispersion behavior for those waves to calculate local surface mass densities in the vicinity of each wave. We find that the inner three-quarters of the A ring (up to the beginning of the Encke gap) has an average surface mass density of 43.8+/-7.9 gcm-2, while the outer region has an average surface mass density of 28.3+/-10.8 gcm-2. The two regions have different mean surface mass densities with a significance of approximately 0.999993, as estimated with a T-statistic, which corresponds to about 4.5σ. While the mean optical depth of the A ring increases slightly with increasing distance from Saturn, we find that it is not significantly correlated with the surface mass density; the two quantities having a linear Pearson's correlation coefficient of rcorr~-0.03. The variation of mass density, independent of PPS optical depth, is consistent with previous conjectures that the particle size distribution and composition are not constant across the entire A ring, particularly in the very outer portion. We estimate the mass of Saturn's A ring from our surface mass density estimates as 4.9×1021 gm, or 8.61×10-9 of the mass of Saturn, roughly equivalent to the mass of a 110-km diameter icy satellite. This mass is almost 25% smaller than estimates from previous studies, but is well within the expected errors of the derived mass densities. We also identified three previously unstudied features which exhibit linear dispersion. The strongest of these features is tentatively identified as the Janus 13:11 density wave. The other two features do not fall near any known satellite resonances and may represent density waves created by previously undetected satellites.
Lane Arthur L.
Nelson Robert M.
Pilorz Stuart
Pollard Benjamin
Russell Christopher T.
No associations
LandOfFree
Saturn A ring surface mass densities from spiral density wave dispersion behavior does not yet have a rating. At this time, there are no reviews or comments for this scientific paper.
If you have personal experience with Saturn A ring surface mass densities from spiral density wave dispersion behavior, we encourage you to share that experience with our LandOfFree.com community. Your opinion is very important and Saturn A ring surface mass densities from spiral density wave dispersion behavior will most certainly appreciate the feedback.
Profile ID: LFWR-SCP-O-845678