Quantification of drying induced acidity at the mineral-water interface using ATR-FTIR spectroscopy

Details Quantification of drying induced acidity at the mineral-water interface using ATR-FTIR spectroscopy Quantification of drying induced acidity at the mineral-water interface using ATR-FTIR spectroscopy

Sep 2011

adsabs.harvard.edu/cgi-bin/nph-data_query?bibcode=2011gecoa..75.4846c&link_type=abstract

Geochimica et Cosmochimica Acta, Volume 75, Issue 17, p. 4846-4856.

Computer Science

Scientific paper

Drying induced pH changes were quantified on the surface of Na+, Ca2+, Mg2+ and Al3+ saturated smectite and kaolinite clays. This was achieved using attenuated total reflectance Fourier transform infrared (ATR-FTIR) spectroscopy to measure real time changes to a pH indicator, sorbed to the clay mineral surface, during wetting and drying events. Using this technique it was possible to measure how low the pH of the surface drops during dehydration, the critical water content at which acidification of the surface begins and lastly how reversible the pH decrease is. The results show that only Al3+-smectite shows acidification below pH 4.8 with drying. The pH starts to decrease on the Al3+-smectite surface even when significantly hydrated (gravimetric water content ˜ 125 mg/m2), and falls to between 1.2 and 1.4 when completely air dry. The drying induced pH decrease is completely reversible on rewetting, suggesting large pH oscillations may occur on smectite surfaces with appreciable exchangeable Al3+. Aluminium saturated kaolinite did not show significant acidification in response to drying (pH > 3.5), however, a 0.1 M AlCl3 solution evaporated to a final pH of 2.8. The enhanced acidification observed on an Al-smectite clay compared to a solution containing free Al3+ ions highlights the role of highly charged surfaces in the hydrolysis reaction that occurs within the hydration shell of exchangeable Al3+ ions.

Affiliated with

Also associated with

No associations

Rating

Quantification of drying induced acidity at the mineral-water interface using ATR-FTIR spectroscopy does not yet have a rating. At this time, there are no reviews or comments for this scientific paper.

If you have personal experience with Quantification of drying induced acidity at the mineral-water interface using ATR-FTIR spectroscopy, we encourage you to share that experience with our LandOfFree.com community. Your opinion is very important and Quantification of drying induced acidity at the mineral-water interface using ATR-FTIR spectroscopy will most certainly appreciate the feedback.

Rate now

Comments { 0 }

Profile ID: LFWR-SCP-O-1400383