Fluid-mineral equilibria in a hydrothermal system, Roosevelt hot springs, Utah

Other

Scientific paper

Rate now

  [ 0.00 ] – not rated yet Voters 0   Comments 0

Details

1

Scientific paper

The availability of fluids and drill cuttings from the active hydrothermal system at Roosevelt Hot Springs allows a quantitative comparison between the observed and predicted alteration mineralogy, calculated from fluid-mineral equilibria relationships. Comparison of all wells and springs in the thermal area indicates a common reservoir source, and geothermometer calculations predict its temperature to be higher (288° C ± 10°) than the maximum measured temperature of 268°C. The composition of the deep reservoir fluid was estimated from surface well samples, allowing for steam loss, gas release, mineral precipitation and ground-water mixing in the well bore. This deep fluid is sodium chloride in character, with approximately 9700 ppm dissolved solids, a pH of 6.0, and gas partial pressures of O 2 ranging from 10 -32 to 10 -35 atm, CO 2 of 11 atm, H 2 S of 0.020 atm and CH 4 of 0.001 atm. Comparison of the alteration mineralogy from producing and nonproducing wells allowed delineation of an alteration pattern characteristic of the reservoir rock. Theoretical alteration mineral assemblages in equilibrium with the deep reservoir fluid, between 150° and 300°C, in the system Na 2 O-K 2 O-CaO-MgO-FeO-Fe 2 O 3 -Al 2 O 3 -H 4 SiO 4 -H 2 O-H 2 S-CO 2 -HCl, were calculated. Minerals theoretically in equilibrium with the calculated reservoir fluid at >240° C include sericite, K-feldspar, quartz, chalcedony, hematite, magnetite and pyrite. This assemblage corresponds with observed higher-temperature (>210° C ) alteration assemblage in the deeper parts of the producing wells. The presence of montmorillonite and mixed-layer clays with the above assemblage observed at temperatures <210°C corresponds with minerals predicted to be in equilibrium with the fluid below 240°C. Alteration minerals present in the reservoir rock that do not exhibit equilibrium with respect to the reservoir fluid include epidote, anhydrite, calcite and chlorite. These may be products of an earlier hydrothermal event, or processes such as boiling and mixing, or a result of errors in the equilibrium calculations as a result of inadequate thermochemical data.

No associations

LandOfFree

Say what you really think

Search LandOfFree.com for scientists and scientific papers. Rate them and share your experience with other people.

Rating

Fluid-mineral equilibria in a hydrothermal system, Roosevelt hot springs, Utah does not yet have a rating. At this time, there are no reviews or comments for this scientific paper.

If you have personal experience with Fluid-mineral equilibria in a hydrothermal system, Roosevelt hot springs, Utah, we encourage you to share that experience with our LandOfFree.com community. Your opinion is very important and Fluid-mineral equilibria in a hydrothermal system, Roosevelt hot springs, Utah will most certainly appreciate the feedback.

Rate now

     

Profile ID: LFWR-SCP-O-900670

  Search
All data on this website is collected from public sources. Our data reflects the most accurate information available at the time of publication.