Mathematics – Logic
Scientific paper
Aug 1992
adsabs.harvard.edu/cgi-bin/nph-data_query?bibcode=1992gecoa..56.3179f&link_type=abstract
Geochimica et Cosmochimica Acta, vol. 56, Issue 8, pp.3179-3190
Mathematics
Logic
2
Scientific paper
Mineral assemblage solubilities were measured in cold-seal pressure vessels as a function of pressure, temperature, and potassium chloride concentration in order to determine the nature and thermodynamic properties of iron-chloride complexes under hydrothermal conditions. The assemblage pyritepyrrhotite-magnetite was used to buffer f S 2 and f O 2 , and K + / H + ratios were buffered at reasonable geologic values using the assemblage potassium feldspar-muscovite (or andalusite)-quartz. The pressure-temperature ranges were 0.5-2.0 kbar and 300-600°C, and initial fluid compositions ranged from 0.01-2.0 molal KCl. With all other factors constant, the concentration of iron in solution increases with increasing temperature, with decreasing pressure, and with increasing total potassium chloride concentration. Changes in iron concentrations as a function of KCl concentration, in conjunction with charge balance, mass action, and mass balance constraints on the system, place constraints on the stoichiometry of the important iron-chloride complexes under each of the experimental conditions. Using least-squared linear regression fits to determine these slopes, the calculations yield values for the average ligand numbers that are in the range 1.2-1.9, with uncertainties ranging from ±0.1-0.6 at the several PT conditions considered. The slopes of the regressed fits to the data suggest that both FeCl + and FeCl 2 0 are important in the experimental fluids, with FeCl 2 0 becoming dominant at the higher temperatures. Theoretical calculations, however, indicate that FeCl + does not contribute significantly to the solubility. Because of the large uncertainties associated with some of the calculated average ligand numbers, we base our data analysis on the theoretical calculations. A statistical analysis is applied to the solubility data in order to determine the values and uncertainties of the dissociation constant for FeCl 2 0 that best fit the data at each of the experimental pressures and temperatures. The calculated stability of FeCl 2 0 increases with increasing temperature and total chloride concentration, and with decreasing pressure. The values of the dissociation constant of FeCl 2 0 that are calculated in this study are in moderately good agreement with FeCl 2 0 dissociation constants from other studies of iron-chloride complexing in supercritical fluids. Differences are likely due to different assumptions made concerning activity coefficients of aqueous species. Log k d values for full dissociation of FeCl 2 0 at 0.5 kbar--300°C--and at 1 kbar--400, 500, and 600°C, respectively--are -3.75 ± 0.40, -6.25 ± 0.10, -9.19 ± 0.44, and -13.29 ± 0.09.
D'Angelo W. M.
Fein Jeremy B.
Hemley J. J.
Komninou A.
Sverjensky Dimitri A.
No associations
LandOfFree
Experimental study of iron-chloride complexing in hydrothermal fluids does not yet have a rating. At this time, there are no reviews or comments for this scientific paper.
If you have personal experience with Experimental study of iron-chloride complexing in hydrothermal fluids, we encourage you to share that experience with our LandOfFree.com community. Your opinion is very important and Experimental study of iron-chloride complexing in hydrothermal fluids will most certainly appreciate the feedback.
Profile ID: LFWR-SCP-O-1166784