Computer Science – Other Computer Science
Scientific paper
2008-05-07
Dans Symposium on Design, Test, Integration and Packaging of MEMS/MOEMS - DTIP 2008, Nice : France (2008)
Computer Science
Other Computer Science
Submitted on behalf of EDA Publishing Association (http://irevues.inist.fr/handle/2042/16838)
Scientific paper
A novel fabrication process, which uses wafer transfer and micro-electroplating technique, has been proposed and tested. In this paper, the effects of the diaphragm thickness and stress, the air-gap thickness, and the area ratio of acoustic holes to backplate on the sensitivity of the condenser microphone have been demonstrated since the performance of the microphone depends on these parameters. The microphone diaphragm has been designed with a diameter and thickness of 1.9 mm and 0.6 $\mu$m, respectively, an air-gap thickness of 10 $\mu$m, and a 24% area ratio of acoustic holes to backplate. To obtain a lower initial stress, the material used for the diaphragm is polyimide. The measured sensitivities of the microphone at the bias voltages of 24 V and 12 V are -45.3 and -50.2 dB/Pa (at 1 kHz), respectively. The fabricated microphone shows a flat frequency response extending to 20 kHz.
Chang Chao-Chih
Chen Guan-Wei
Chen Ji-Liang
Horng Ray Hua
Ke Ming-Li
No associations
LandOfFree
Design And Fabrication of Condenser Microphone Using Wafer Transfer And Micro-electroplating Technique does not yet have a rating. At this time, there are no reviews or comments for this scientific paper.
If you have personal experience with Design And Fabrication of Condenser Microphone Using Wafer Transfer And Micro-electroplating Technique, we encourage you to share that experience with our LandOfFree.com community. Your opinion is very important and Design And Fabrication of Condenser Microphone Using Wafer Transfer And Micro-electroplating Technique will most certainly appreciate the feedback.
Profile ID: LFWR-SCP-O-489994