Design and Fabrication of a Micro Electrostatic Vibration-to-Electricity Energy Converter

Details Design and Fabrication of a Micro Electrostatic Vibration-to-Electricity Energy Converter Design and Fabrication of a Micro Electrostatic Vibration-to-Electricity Energy Converter

2007-11-21

arxiv.org/abs/0711.3313v1

Dans Symposium on Design, Test, Integration and Packaging of MEMS/MOEMS - DTIP 2006, Stresa, Lago Maggiore : Italie (2006)

Computer Science

Other Computer Science

Submitted on behalf of TIMA Editions (http://irevues.inist.fr/tima-editions)

Scientific paper

This paper presents a micro electrostatic vibration-toelectricity energy converter. For the 3.3 V supply voltage and 1cm2 chip area constraints, optimal design parameters were found from theoretical calculation and Simulink simulation. In the current design, the output power is 200 $\mu$W/cm2 for the optimal load of 8 M\Omega. The device was fabricated in a silicon-on-insulator (SOI) wafer. Mechanical and electrical measurements were conducted. Residual particles caused shortage of the variable capacitor and the output power could not be measured. Device design and fabrication processes are being refined.

Affiliated with

Also associated with

No associations

Rating

Design and Fabrication of a Micro Electrostatic Vibration-to-Electricity Energy Converter does not yet have a rating. At this time, there are no reviews or comments for this scientific paper.

If you have personal experience with Design and Fabrication of a Micro Electrostatic Vibration-to-Electricity Energy Converter, we encourage you to share that experience with our LandOfFree.com community. Your opinion is very important and Design and Fabrication of a Micro Electrostatic Vibration-to-Electricity Energy Converter will most certainly appreciate the feedback.

Rate now

Comments { 0 }

Profile ID: LFWR-SCP-O-414108