Other
Scientific paper
May 2004
adsabs.harvard.edu/cgi-bin/nph-data_query?bibcode=2004e%26psl.222..209b&link_type=abstract
Earth and Planetary Science Letters, Volume 222, Issue 1, p. 209-216.
Other
18
Continental Subduction, Thermomechanics Of The Lithosphere, Physical Modelling, Exhumation, High-Pressure Rocks
Scientific paper
Thermo-mechanical physical modelling of continental subduction is performed to investigate the exhumation of deeply subducted continental crust. The model consists of two lithospheric plates made of new temperature sensitive analogue materials. The lithosphere is underlain by liquid asthenosphere. The continental lithosphere contains three layers: the weak sedimentary layer, the crust made of a stronger material, and of a still stronger lithospheric mantle. The whole model is subjected to a constant vertical thermal gradient, causing the strength reduction with depth in each lithospheric layer. Subduction is driven by both push force and pull force. During subduction, the subducting lithosphere is heating and the strength of its layers reduces. The weakening continental crust reaches maximal depth of about 120 km and cannot subduct deeper because its frontal part starts to flow up. The subducted crust undergoes complex deformation, including indicated upward ductile flow of the most deeply subducted portions and localised failure of the subducted upper crust at about 50-km depth. This failure results in the formation of the first crustal slice which rises up between the plates under the buoyancy force. This process is accompanied by the delamination of the crustal and mantle layers of the subducting lithosphere. The delamination front propagates upwards into the interplate zone resulting in the formation of two other crustal slices that also rise up between the plates. Average equivalent exhumation rate of the crustal material during delamination is about 1 cm/year. The crust-asthenosphere boundary near the interplate zone is uplifted. The subducted mantle layer then breaks off, removing the pull force and thereby stopping the delamination and increasing horizontal compression of the lithosphere. The latter produces shortening of the formed orogen and the growth of relief. The modelling reveals an interesting burial/exhumation evolution of the sedimentary cover. During initial stages of continental subduction the sediments of the continental margin are dragged to the overriding plate base and are partially accreted at the deep part of the interplate zone (at 60-70 km-depth). These sediments remain there until the beginning of delamination during which the pressure between the subducted crust and the overriding plate increases. This results in squeezing the underplated sediments out. Part of them is extruded upwards along the interplate zone to about 30-km depth at an equivalent rate of 5-10 cm/year.
Boutelier David
Chemenda Alexandre
Jorand Cedric
No associations
LandOfFree
Continental subduction and exhumation of high-pressure rocks: insights from thermo-mechanical laboratory modelling does not yet have a rating. At this time, there are no reviews or comments for this scientific paper.
If you have personal experience with Continental subduction and exhumation of high-pressure rocks: insights from thermo-mechanical laboratory modelling, we encourage you to share that experience with our LandOfFree.com community. Your opinion is very important and Continental subduction and exhumation of high-pressure rocks: insights from thermo-mechanical laboratory modelling will most certainly appreciate the feedback.
Profile ID: LFWR-SCP-O-1057633