Comparison of bar strengths in optical and near-infrared for the OSUBSGS sample

Details Comparison of bar strengths in optical and near-infrared for the OSUBSGS sample Comparison of bar strengths in optical and near-infrared for the OSUBSGS sample

2007-10-05

arxiv.org/abs/0710.1180v1

Astronomy and Astrophysics

Astrophysics

15 pages, 9 figures, 1 table, accepted to MNRAS

Scientific paper

10.1111/j.1365-2966.2007.12548.x

We use a gravitational bar torque method to compare bar strengths (the maximum tangential force normalized by radial force) in B and H-band images of 152 galaxies from the Ohio State University Bright Spiral Galaxy Survey. Our main motivation is to check how much the difference in the rest-frame wavelength could affect comparisons of bar strengths in low and high redshift observations. Between these two bands we find an average bar strength ratio Q_B/H= 1.25 which factor is nearly independent of the morphological type. We show that Q_B/H > 1 is mostly due to reduced bulge dilution of radial forces in the B-band. The bar torque method needs an estimate for the vertical scale height of the galaxy, based on the radial scale length of the disk and the galaxy's morphological type. Since these two might not always be possible to determine at high redshifts in a reliable manner, we also checked that similar results are obtained with vertical scale heights estimated from the radii corresponding to the K-band surface brightness of 20 mag/arcsec^2. Also, we made a simple test of the usability of the bar torque method at high redshifts by checking the effects of image degradation (nearest neighbour sampling without any adjustment of noise levels): we found that the estimated bar strengths varied by +/- 10% at most as long as the total extent of the bar was at least 10 pixels. Overall, we show that the gravitational bar torque method should provide a proficient tool for quantifying bar strengths also at high redshifts.

Affiliated with

Also associated with

No associations

Rating

Comparison of bar strengths in optical and near-infrared for the OSUBSGS sample does not yet have a rating. At this time, there are no reviews or comments for this scientific paper.

If you have personal experience with Comparison of bar strengths in optical and near-infrared for the OSUBSGS sample, we encourage you to share that experience with our LandOfFree.com community. Your opinion is very important and Comparison of bar strengths in optical and near-infrared for the OSUBSGS sample will most certainly appreciate the feedback.

Rate now

Comments { 0 }

Profile ID: LFWR-SCP-O-328914