Astronomy and Astrophysics – Astrophysics
Scientific paper
Feb 1994
adsabs.harvard.edu/cgi-bin/nph-data_query?bibcode=1994stin...9513636t&link_type=abstract
Unknown
Astronomy and Astrophysics
Astrophysics
Calibrating, Focusing, Satellite Instruments, Sim, Spacecraft Design, X Ray Astrophysics Facility, Linkages, Rotation, Temperature Gradients, Translating
Scientific paper
The design requirements and initial design concept for the AXAF-I Science Instrument Module (SIM) were reviewed at Ball on September 29, 1993. The concept design SIM focus mechanism utilizes a planetary gearset, with redundant motors, to drive a large ring (called 'main housing bearing') via a spur gearset. This large drive ring actuates three tangent bar links (called 'push rods'), which in turn actuate three levers (called 'pin levers'). Each of the three pin levers rotates an 'eccentric pin,' which in turn moves the base of a bipod flexure in both the radial (normal to optical axis) and axial (focus along optical axis) directions. Three bipod flexures are employed, equally spaced at 120 degrees apart, the base of each being translated in the two directions as described above. A focus adjustment is made by rotating the drive ring, which drives the push rods and therefore the pin levers, which in turn rotate the eccentric pins, finally imparting the two motions to the base of each of the bipod flexures. The axial translation (focus adjustment) of the focused structure is the sum of the direct axial motion plus axial motion which comes from uniformly squeezing the three bipod bases radially inward. SAO documented the following concerns regarding the focus mechanism in memo WAP-FY94-001, dated October 7, 1993: (1) The focus adjustment depends, in large part, on the structural properties (stiffnesses and end fixities) of the bipod flexures, push rods, pin levers and eccentric pins. If these properties are not matched very well, then lateral translations as well as unwanted rotations of the focussed structure will accompany focus motion. In addition, the stackup of linkage tolerances and any nonuniform wear in the linkages will result in the same unwanted motions. Thermal gradients will also affect these motions. At the review Ball did not present supporting analyses to support their choice of this design concept. (2) The proposed 'primary' method of measuring focus is by counting motor steps. The 'backup' method is by a pot mounted on the drive ring. Neither method provides for a direct measurement of the quantity desired (focus position). This is of concern because of the long and indirect relationship between focus and the sensed quantity (drive ring rotation). There are three sinusoidal relationships and structural stiffness in the path, and the resulting calibration is likely to be highly nonlinear. These methods would require an accurate ground calibration. (3) Ground calibration (and verification) of focus vs. drive position must be done in 1-g on the ground. This calibration will be complicated by both the structural characteristics of the bipods and the fact that the CG of the translating portion of the SIM is not on the optical axis (thereby causing unwanted rotations and changing the focus position vs. motor step and pot readout relationships).
Tananbaum Harvey Dale
Whitbeck Elizabeth
No associations
LandOfFree
AXAF SIM focus mechanism study does not yet have a rating. At this time, there are no reviews or comments for this scientific paper.
If you have personal experience with AXAF SIM focus mechanism study, we encourage you to share that experience with our LandOfFree.com community. Your opinion is very important and AXAF SIM focus mechanism study will most certainly appreciate the feedback.
Profile ID: LFWR-SCP-O-957337