Formation of thin sulfide rinds on the CM parent body

Details Formation of thin sulfide rinds on the CM parent body Formation of thin sulfide rinds on the CM parent body

Jul 1994

adsabs.harvard.edu/cgi-bin/nph-data_query?bibcode=1994metic..29r.450b&link_type=abstract

Meteoritics (ISSN 0026-1114), vol. 29, no. 4, p. 450-450

Computer Science

1

Chondrites, Meteoritic Composition, Olivine, Precipitation (Chemistry), Sulfides, Evolution (Development), Mineralogy, Particle Size Distribution, Solubility, Textures

Scientific paper

Many of the textures that are observed in CM chondrites have been alternately assigned nebular, parent-body, or combined nebular-parent body origins. Since it is very difficult to substantiate the production of complex textures in the nebula, an alternate approach to this problem is to rigorously determine which of the observable textures could have been produced by reasonable aqueous alteration processes on the CM parent body. Potential parent body reactions involving S deserve special attention because S-bearing phase define many important CM textures, such as rims. We have examined the possibility that the thin (about 5 microns) rinds of sulfides observed around some partially dissolved olivines within the chondrules and matrixes of CM chondrites were formed by the preferential precipitation of sulfides at or near dissolving olivine boundaries during parent-body alteration. Our model defines two infinite and parallel planes of olivine that are separated by pure water. Average separation distances between olivine grains in CM chondrites at the time of accretion (about 100-200 microns) were estimated by assuming a closed system fluid/rock ratio of 45% and varying the bimodal grain-size distribution. We restrict our calculations to the case of an isochemical system with sufficient bisulfide in solution to account for precipitation of pyrrhotite at STP. Our model examines the possibility that dissolving olivines with compositions between Fo0.9 and Fo0.4 can produce a strong gradient of Fe(2+) at pHs from 7 to 12 such that the precipitation of pyrrhotite will be initiated at the olivine-fluid boundary. Since CM phase equilibria is consistent with highly reducing conditions, Fe released by olivines would largely remain in solution as Fe(2+) until the solubility product of a Fe(2+) bearing phase was exceeded. Our calculations indicate that all examined combinations of olivine composition and pH yield a strong Fe(2+) gradient at the time the pyrrhotite solubility is exceeded near the olivine-fluid boundary. This favors the initiation of sulfide precipitation around dissolving olivines. However, sulfide rinds are not observed around all partially dissolved olivine grains in CM chondrites, which suggests that the availability of aqueous sulfide species limits the production of the thin sulfide rinds.

Affiliated with

Also associated with

No associations

Rating

Formation of thin sulfide rinds on the CM parent body does not yet have a rating. At this time, there are no reviews or comments for this scientific paper.

If you have personal experience with Formation of thin sulfide rinds on the CM parent body, we encourage you to share that experience with our LandOfFree.com community. Your opinion is very important and Formation of thin sulfide rinds on the CM parent body will most certainly appreciate the feedback.

Rate now

Comments { 0 }

Profile ID: LFWR-SCP-O-822285