Seismic gravity-gradient noise in interferometric gravitational-wave detectors

Astronomy and Astrophysics – Astrophysics – General Relativity and Quantum Cosmology

Scientific paper

Rate now

  [ 0.00 ] – not rated yet Voters 0   Comments 0

Details

30 pages, Revtex, 12 figures, submitted to Phys Rev D

Scientific paper

10.1103/PhysRevD.58.122002

When ambient seismic waves pass near an interferometric gravitational-wave detector, they induce density perturbations in the earth which produce fluctuating gravitational forces on the interferometer's test masses. These forces mimic a stochastic background of gravitational waves and thus constitute noise. We compute this noise using the theory of multimode Rayleigh and Love waves propagating in a layered medium that approximates the geological strata at the LIGO sites. We characterize the noise by a transfer function $T(f) \equiv \tilde x(f)/\tilde W(f)$ from the spectrum of direction averaged ground motion $\tilde W(f)$ to the spectrum of test mass motion $\tilde x(f) = L\tilde h(f)$ (where $L$ is the length of the interferometer's arms, and $\tilde h(f)$ is the spectrum of gravitational-wave noise). This paper's primary foci are (i) a study of how $T(f)$ depends on the various seismic modes; (ii) an attempt to estimate which modes are excited at the LIGO sites at quiet and noisy times; and (iii) a corresponding estimate of the seismic gravity-gradient noise level. At quiet times the noise is below the benchmark noise level of ``advanced LIGO interferometers'' (although not by much near 10 Hz); it may significantly exceed this level at noisy times. The lower edge of our quiet-time noise is a limit beyond which there is little gain from further improvements in vibration isolation and thermal noise, unless one also reduces seismic gravity-gradient noise. Two methods of reduction are discussed: monitoring the earth's density perturbations, computing their gravitational forces, and correcting the data for those forces; and constructing narrow moats around the interferometers' test masses to shield out the fundamental-mode Rayleigh waves, which we suspect dominate at quiet times.

No associations

LandOfFree

Say what you really think

Search LandOfFree.com for scientists and scientific papers. Rate them and share your experience with other people.

Rating

Seismic gravity-gradient noise in interferometric gravitational-wave detectors does not yet have a rating. At this time, there are no reviews or comments for this scientific paper.

If you have personal experience with Seismic gravity-gradient noise in interferometric gravitational-wave detectors, we encourage you to share that experience with our LandOfFree.com community. Your opinion is very important and Seismic gravity-gradient noise in interferometric gravitational-wave detectors will most certainly appreciate the feedback.

Rate now

     

Profile ID: LFWR-SCP-O-589705

  Search
All data on this website is collected from public sources. Our data reflects the most accurate information available at the time of publication.