Statistics – Computation
Scientific paper
May 2001
adsabs.harvard.edu/cgi-bin/nph-data_query?bibcode=2001aas...198.0502h&link_type=abstract
American Astronomical Society, 198th AAS Meeting, #05.02; Bulletin of the American Astronomical Society, Vol. 33, p.791
Statistics
Computation
1
Scientific paper
We have designed and programmed a digital motion control system for large telescopes, in particular, the 6-meter antennas of the Submillimeter Array on Mauna Kea. The system consists of a single robust, high-reliability microcontroller board which implements a two-axis velocity servo while monitoring and responding to critical safety parameters. Excellent tracking performance has been achieved with this system (0.3 arcsecond RMS at sidereal rate). The 24x24 centimeter four-layer printed circuit board contains a multitude of hardware devices: 40 digital inputs (for limit switches and fault indicators), 32 digital outputs (to enable/disable motor amplifiers and brakes), a quad 22-bit ADC (to read the motor tachometers), four 16-bit DACs (that provide torque signals to the motor amplifiers), a 32-LED status panel, a serial port to the LynxOS PowerPC antenna computer (RS422/460kbps), a serial port to the Palm Vx handpaddle (RS232/115kbps), and serial links to the low-resolution absolute encoders on the azimuth and elevation axes. Each section of the board employs independent ground planes and power supplies, with optical isolation on all I/O channels. The processor is an Intel 80C196KC 16-bit microcontroller running at 20MHz on an 8-bit bus. This processor executes an interrupt-driven, scheduler-based software system written in C and assembled into an EPROM with user-accessible variables stored in NVSRAM. Under normal operation, velocity update requests arrive at 100Hz from the position-loop servo process running independently on the antenna computer. A variety of telescope safety checks are performed at 279Hz including routine servicing of a 6 millisecond watchdog timer. Additional ADCs onboard the microcontroller monitor the winding temperature and current in the brushless three-phase drive motors. The PID servo gains can be dynamically changed in software. Calibration factors and software filters can be applied to the tachometer readings prior to the application of the servo gains in the torque computations. The Palm pilot handpaddle displays the complete status of the telescope and allows full local control of the drives in an intuitive, touchscreen user interface which is especially useful during reconfigurations of the antenna array.
Hunter Todd Russell
Kimberk Robert
Leiker Patrick S.
Wilson Richard W.
No associations
LandOfFree
A Digital Motion Control System for Large Telescopes does not yet have a rating. At this time, there are no reviews or comments for this scientific paper.
If you have personal experience with A Digital Motion Control System for Large Telescopes, we encourage you to share that experience with our LandOfFree.com community. Your opinion is very important and A Digital Motion Control System for Large Telescopes will most certainly appreciate the feedback.
Profile ID: LFWR-SCP-O-1267486