Lower slab boundary in the Japan subduction zone

Details Lower slab boundary in the Japan subduction zone Lower slab boundary in the Japan subduction zone

Jul 2006

adsabs.harvard.edu/cgi-bin/nph-data_query?bibcode=2006e%26psl.247..101t&link_type=abstract

Earth and Planetary Science Letters, Volume 247, Issue 1-2, p. 101-107.

Computer Science

4

Scientific paper

We have successfully detected the lower boundary of a subducting slab. The successive imaging of the lower slab boundary beneath northeastern (NE) Japan is attained by receiver function (RF) depth conversion analysis using a recent 3D tomographic velocity model. We use waveforms from 249 teleseismic events collected by Hi-net and J-array short-period stations in NE Japan. RFs are calculated through frequency domain division of radial components by vertical ones with a water level of 0.001 and a 1.0 Hz low-pass Gaussian filter. Assuming that all later phases in the radial RFs are due to Ps phases converted at discontinuities beneath stations, we calculate depth-converted RFs, mapped onto the cross-section with the CCP (common conversion point) stacking. In a cross section, the slab surface and the oceanic Moho can be imaged down to 120 km depth. For the greater depths, the RF amplitudes corresponding to them cannot be seen, because, in the oceanic crust, basalt would be completely metamorphosed to eclogite below this depth. The lower boundary of the Pacific slab can also be traced down to 200 km depth or more. It is parallel to the slab surface and the oceanic Moho, and the thickness between the slab surface and the lower boundary is ˜ 80 km. Finally, we estimate a top-to-bottom slab velocity model that explains the RFs observed at broadband stations with the synthetic RFs. This model exhibits a 13% velocity reduction downwards the lower slab boundary, which would relatively sharp for the base of the thermal boundary layer. Therefore, this sharp discontinuity is presumably considered to be the subducting G (Gutenberg) discontinuity that is formed by the change of the amount of H2O (water), meaning that the G discontinuity is the chemical boundary at the bottom of the oceanic lithosphere. The G discontinuity depth is controlled by the potential temperature of the asthenospheric mantle beneath the mid-ocean ridge, and hence the observed thickness of 80 km, i.e. the G discontinuity depth, corresponds to 1375 °C in potential temperature when this boundary is formed.

Affiliated with

Also associated with

No associations

Rating

Lower slab boundary in the Japan subduction zone does not yet have a rating. At this time, there are no reviews or comments for this scientific paper.

If you have personal experience with Lower slab boundary in the Japan subduction zone, we encourage you to share that experience with our LandOfFree.com community. Your opinion is very important and Lower slab boundary in the Japan subduction zone will most certainly appreciate the feedback.

Rate now

Comments { 0 }

Profile ID: LFWR-SCP-O-1140662